IsoPrime User’s Guide
Version 1.01 IsoPrime100 User’s Guide Page 3 of 219
ISOPRIME100 USER’S GUIDE
WARRANTY
The information contained within this document is subject to change without notice
Isoprime Ltd. makes no warranty of any kind with regard to this material, including, but not
limited to, the implied warranties of merchantability and fitness for a particular purpose.
Isoprime Ltd. shall not be liable for errors contained herein or for incidental damages in
connection with the furnishing, performance, or use of this material.
SAFETY INFORMATION
The IsoPrime100 mass spectrometer meets the following IEC (International Electromechanical
Commission) classifications:
Safety Class 1
Transient Over Voltage Category II
Pollution Degree 2
You must comply with all local and national requirements for electrical and mechanical safety.
The instrument has been designed and tested in accordance with recognized safety standards. If
the instrument is used in a manner not specified by the manufacturer, the protection provided
by the instrument may be impaired.
Whenever the safety protection of the IsoPrime100 is compromised, disconnect the instrument
from all power sources and secure the unit against unintended operation.
Suitably qualified personnel only should perform maintenance procedures. Substituting parts or
performing any unauthorized modification to the instrument may result in a safety hazard.
Disconnect the mains supply before removing covers.
Please contact the customer service department at the above address, or your local Isoprime
representative, should you require any further information.
To Next Page
Loading...