Isoprime 100 - Selecting Samples; Inserting Samples; Adding Samples

IsoPrime User’s Guide
Version 1.01 IsoPrime100 User’s Guide Page 67 of 219
SELECTING SAMPLES
To select samples, click on the plate containing the samples of interest in the bed layout. The
plate number will change to the appropriate value.
Select the samples to be run by using one of the following methods:
 Click on the individual sample locations on the plate plan. The sample positions
will turn green when selected. To de-select a sample, click on the sample
position again.
 Click and drag a box around the samples of interest. All the samples contained
within the box will be selected. To de-select the samples, draw another box
around them.
 Click on the select all button , or select none button .
INSERTING SAMPLES
Insert new samples (rows) into the sample list as follows:
 Select the samples in the plate layout pane (see above).
 The insert button will insert the samples below the highlighted area. Select the row in
the sample list above where the new samples are to be inserted.
 Press the insert samples button .
The samples are inserted into the sample list above the selected row. Any information already
present in the row above the selected row is duplicated into the new rows. The names and
bottle numbers of the new samples are automatically incremented.
ADDING SAMPLES
Add new samples to the sample list as follows:
 Select the samples in the plate layout pane.
 Press the add samples button .
The samples are added to the end of the sample list. Any information in the bottom row of the
list is duplicated into the new rows. The names and bottle numbers of the new samples are
automatically incremented.