Isoprime User’s Guide
Version 1.02 IsoPrime100 User’s Guide Page 4 of 219
SAFETY SYMBOLS
Warnings in this manual or on the instrument must be observed during all phases of service,
repair, installation and operation of the instrument. Failure to comply with these precautions
violates the safety standards of design and the intended use of the instrument.
Isoprime Ltd. assumes no liability for the customer’s failure to comply with these requirements.
The following safety symbols are used in the manual or on the instrument. Warnings are given
to highlight situations or conditions where failure to observe the instruction could result in
injury or death to persons. Cautions are given to highlight situations or conditions where failure
to observe the instruction could result in damage to the
equipment, associated equipment or process.
Warning: this is a general warning symbol, indicating that there is a
potential health or safety hazard.
Warning: this symbol indicates that hazardous voltages may be present.
Warning: this symbol indicates that hot surfaces may be present.
Warning: this symbol indicates that there is danger from corrosive
substances.
Warning: this symbol indicates that there is danger from toxic substances.
Caution: this is a general caution symbol, indicating that care must be taken
to avoid the possibility of damaging the instrument or affecting its
operation.
Warning: high magnetic fields. Pacemaker wearers should not approach any
closer than 1m.
To Next Page
Loading...