Isoprime User’s Guide
Version 1.02 IsoPrime100 User’s Guide Page 52 of 219
Plates and Racks. These folders contain definitions of the plates and beds
used by auto samplers.
RIOINI. This folder contains hardware configuration information which defines
how the instrument is controlled.
The SIRMS folder contains data processing files and the reference library
IONVANTAGE PROJECTS
INTRODUCTION
IonVantage projects are used to organise the data acquired by the IsoPrime100. A project
contains all the information involved in the analysis of a sample. This includes the
files that control the inlet, the autosampler, the source tuning and the acquisition,
together with the sample lists, sample data and any subsequent batch analysis results.
An IonVantage project is identified by the extension .PRO appended to the end of the project
name, such as Default.PRO.
By default, all projects are stored in the C:\IonVantage Projects folder, separate from the main
IonVantage program folder. This arrangement means that archived data files are not affected by
any subsequent software re-installation or update.
The name of the current project is shown in the title bar of the sample list, after the
word IonVantage. The project name is followed by the name of the sample list file, for example:
In this example the project is called Test 1
A number of default projects are provided with IonVantage. These can be used as templates
from which the user can set up working projects. A default project is supplied with each of the
IsoPrime100 preparation systems, for example Default DI test.PRO is supplied for the testing
of the dual inlet, and Default GC.PRO is supplied for GC analysis. Each default project
includes all the files necessary for the operation of the related preparation system.
To Next Page