Isuzu D-MAX 2020 User Manual

6-102
SERVICE AND MAINTENANCE
WiperBladeReplacement(FlatBladeType)
To replace the wiper blade, switch the
wiper in the service position.
RTUL60SH009601
Service position
WindshieldWiperSwitch
 →Refertopage4-131
SwitchingtheWiperbetweenthe
ServicePosition/NormalPosition
1. Make sure that the windshield wiper
switch is in the "OFF" position.
2. Switch the power mode to "ON", and
immediately to "OFF" (models with
passive entry and start system), or
turn the starter switch to the "ON"
position, and immediately to the
"LOCK" position (models without
passive entry and start system).
3. Pull up and hold the windshield
washer switch to switch the wiper
position.
Windshield Washer Switch
 →Refertopage4-136
NOTE
• For approximately 1 minute after
performing the operation mentioned
in step 2, it is possible to switch the
wiper position.
ADVICE
• Check that the engine hood is
securely closed.
  EngineHood→Refertopage 6-11
5108428_sec06_SERVICE AND MAINTENANCE_P001-140.indd 102 2020/11/05 11:54:19

Isuzu D-MAX 2020 Specifications

General

Brand	Isuzu
Model	D-MAX 2020
Category	Automobile
Language	English