61
English/ Chapter 09
Service Name: Enter a service name.
Service User:
Any: Allow everybody in the user network to use the service.
Single address: Enter the IP address of the network adapter on the
PC. Then, the service is applied only on the specific network adapter
of the PC.
Service Type: The protocol used at the triggering port. You can select
TCP/UDP, TCP, or UDP.
Triggering Starting Port: The first port to which an application sends a
connection request. All relevant ports can be open only after connection
is established at this starting port. Otherwise, other relevant ports are
not open.
Triggering Ending Port: Set the end port of the triggering port range.
Starting Port: The starting port of the port range.
Ending Port: The ending port of the port range. After finishing settings,
click Apply to add a port triggering rule.
To Next Page
Loading...