Basic Operation
6 Basic Operation
This chapter describes the basic functions and features of the instrument. Div-
ided into the following sections:
♦ Local/Remote Mode Switch
♦ Key Lock Function
♦ Save and Recall Operations
♦ Data Logging Function
♦ Set the Beeper Status (Beep)
♦ Set the Power-on State (PowerOn)
♦ Sense Function (Sense)
♦ Select Trigger Source (Trig Source)
♦ Set the Communication Information (I/O Con)
♦ Set Parallel Operation Mode (Parallel)
♦ Digital I/O Function (Digital Port)
♦ Source Analogue Function (Ext-Program) (Optional)
♦ loadAnalogue Function (Ext-Program) (Optional)
♦ Restored to Factory Setting (System Reset)
♦ View the System Information (System Info)
♦ Observe Power Grid Information (AC-Meter)
♦ Display Loading Time (Disp on timer)
♦ System Upgrade
6.1 Local/Remote Mode Switch
The power system provides both local and remote operation modes. The default
mode of the power system is local operation mode.
• Local operation mode: Use the front panel keys to control the power system.
• Remote operation mode: The power system is connected to PC, and the
user uses the software in PC to control the power system remotely.
– During remote control operation, the remote symbol “Rmt” is displayed.
All panel keys, except the [On/Off] and [Shift]+[3] (Local) keys, are
locked.
– You can press [Shift]+[3] (Local) to switch the remote control to local
control. The mode modification will not affect the output parameters of
the power system.
Copyright © Itech Electronic Co., Ltd.
169
To Next Page
Loading...
Need help?
General
