ITech IT6000B Series - Save Operation

Basic Operation
Category
Parameter
OCP/OVP/OPP/UCP/UVP delay time: Delay
UCP/UVP warm-up time: Warm-up
Category
Parameter
Main interface
(Load Mode)
Voltage setting under CV mode: Vs
Current setting under CC mode: Is
Power setting under CW mode: Ps
Resistance setting under CR mode: Rs
Voltage setting and current setting under CVCC mode: Vs
and Is
Voltage setting and resistance setting under CVCR mode:
Vs and Rs
Current setting and resistance setting under CRCC mode:
Is and Rs
Voltage setting, current setting, resistance setting and
power setting under AUTO mode: Vs, Is, Ps and Rs
Config Menu
(Load Mode)
Operation mode
I-Rise Slope
I-Fall Slope
Von function mode and level
You can do the save and recall operations by the following two methods.
• Press the composite keys [Shift]+[+/-] (Save) to save the parameters. Press
the composite keys [Shift]+[0] (Recall) to recall the parameters.
• SCPI commands: *SAV and *RCL
6.3.1 Save Operation
The save operation procedures are as follows:
1. Press the composite keys [Shift]+[+/-] (Save) to enter the parameter save
interface.
Copyright © Itech Electronic Co., Ltd.
171