Basic Operation
2. Set the storage location.
Enter a number in the "Save data to bank=1" to set the storage location in
non-volatile memory.
3. Press [Enter] to save the parameters.
6.3.2 Recall Operation
You can recall the parameters you saved in the specified memory location as
the setting values.
1. Press the composite keys [Shift]+[0] (Recall) to enter the parameter recall
interface.
2. Set the storage location.
Enter a number in the “Recall data from bank=1” to set the storage location
in non-volatile memory.
3. Press [Enter] to recall the parameters.
6.4 Data Logging Function
The IT6000B series Regenerative Power System supports the recording and
saving of test data. This Chapter introduces how to use this function in details.
The user can select the following data sources for recording:
• Voltage
Only records voltage data during the data acquisition period.
• Current
Only records current data during the data acquisition period.
• Voltage and current
Records current and voltage data during the data acquisition period.
Configure the Function Menu
1. Press the composite button [Shift]+[1] (Log) on the front panel to enter the
configuration menu of the data logging function.
The parameters are described as follows:
Copyright © Itech Electronic Co., Ltd.
172
To Next Page
Loading...
Need help?
General
