Basic Operation
Category
Parameter Initial Value
Von level 0V
On Delay/Off Delay 0s
• Last: Indicates when powered on, the instrument will remain the same
parameter settings and output status as last time you powered off the
instrument.
• Last+Off: Indicates when powered on, the instrument will remain the
same settings as last time you powered off the instrument, but the output
status is Off.
4. After the parameter settings are complete, press [Enter].
For example, Last is selected, and the voltage value is set to 20V. After the
instrument is powered off and then powered on, the voltage displayed on the
interface is 20V.
6.7 Sense Function (Sense)
This menu item is used to switch the power system to local measurement or re-
mote sensing.
The IT6000B series power system supports two connection methods: Local
measurement and Remote sensing. The remote sensing is used for maximizing
measurement accuracy. (Refer to 2.5 Connecting the Device Under Test
(DUT))
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the Sense and press
[Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• Off: Default value, indicates turn the sense function off.
• On: Indicates turn the sense function on.
4. After the parameter settings are complete, press [Enter].
Copyright © Itech Electronic Co., Ltd.
179
To Next Page
Loading...
Need help?
General
