ITech IT6000B Series - Page 199

Basic Operation
Minimum high level input
voltage
1.6V
Typical high level output
voltage
5V
Typical low level output
voltage
0V
Level rise slope 10us
Level fall slope 2us
The maximum sink current of each pin is 100mA, and the maximum output
current is 1mA.
Pins Introduction
The appearance of the terminals are shown below.
Pin Description Properties
(Default
function)
Properties
(General I/O
function)
1 Corresponds to the function set in the
System→Digital Port→IO–1. Ps-
Clear, Not-Invert menu item. For pa-
rameter introduction, see 6.11.1 IO–
1. Ps-Clear, Not-Invert.
Pulse signal Level or PWM
signal
2 Corresponds to the function set in the
System→Digital Port→IO–2. Ps,
Not-Invert menu item. For parameter
introduction, see 6.11.2 IO–2. Ps,
Not-Invert.
Level signal Level or PWM
signal
3 Corresponds to the function set in the
System→Digital Port→IO–3. Off-
Level signal Level or PWM
signal
Copyright © Itech Electronic Co., Ltd.
187