Basic Operation
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the System Reset and
press [Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• No: Default value, indicates the instrument cancels this menu setting.
• Yes: Indicates the instrument restores the factory default settings.
4. After the parameter settings are complete, press [Enter].
The parameters affected by System Reset and the parameter values after
reset are shown in the following table.
Table 6–4 Initial value of the parameter
Category
Parameter Initial Value
Main inter-
face
(Source
mode)
Voltage setting: Vs
One percent of the rated
voltage of the
instrument
Current setting: Is One percent of the rated
current of the instrument
Upper limit of voltage: Vh, and
lower limit of voltage: Vl
Upper limit value: One
percent of the rated volt-
age of the instrument
Lower limit value: 0
Upper limit of current: I+, and
lower limit of current: I-
One percent of the rated
current of the instrument
Upper limit of power: P+, and
lower limit of power: P-
Rated power value of
the instrument
[On/Off] status Off
System
menu
Beep On
PowerOn Reset
Sense Off
ListTrig Source Manual
DataLogger Trig Source Manual
I/O Con
• LAN→IP-Conf
Copyright © Itech Electronic Co., Ltd.
216
To Next Page
Loading...
Need help?
General
