Basic Operation
2. Power on the instrument. At this point, press Shift for several times till
the instrument can detect the system upgrading files in the USB flash
drive.
After the system upgrading files are detected, the interface displays as
follows:
Update Select(01/01)
SN: ALL
If the USB flash drive is not detected, select Yes to detect again; if No
is selected, it means to exit upgrading, and the system will directly en-
ter into the main interface.
3. Select ALL, and press [Enter].
The system interface displays as follows:
Update ? (01/01)
No Yes
4. Select Yes, and press [Enter].
The system will automatically perform upgrading.
If No is selected, it means to exit upgrading, and the system will di-
rectly enter into the main interface.
5. After the upgrading is completed, you need to restart the instrument
manually.
• System Upgrade under Parallel Mode (Only Need to Operate the Master)
1. Insert the USB flash drive into the USB interface on the front panel of the
instrument.
2. Power on the instrument. At this point, press Shift for several times till
the instrument can detect the system upgrading files in the USB flash
drive.
After the system upgrading files are detected, the interface displays as
follows:
Update Select(xx/yy)
SN: ALL
xx means the number of selected instruments to be upgraded, and yy
means the number of instruments in the parallel network.
Copyright © Itech Electronic Co., Ltd.
224
To Next Page
Loading...
Need help?
General
