Inspection and Installation
• The cabinet product is very heavy. Before moving to another loca-
tion, confirm whether the ground load is in compliance.
• During the process of moving the cabinet, it is recommended that
two or more people cooperate and push it slowly and at a constant
speed. If you encounter a pit, you need to pay special attention. It is
forbidden to push it quickly, otherwise it will easily cause excessive
inertia and cause the casters at the bottom of the cabinet to jam
and the cabinet to fall.
• It is not advisable to push down the slope to prevent the cabinet
from falling down due to the shift of the center of gravity. It is rec-
ommended to use a forklift or crane to move the cabinet.
• ITECH 27U and 37U cabinets are equipped with hoisting rings as
standard on the top. It is recommended to use a crane equipped
with a four-leg hoisting belt structure for horizontal hoisting and
moving, and ensure that the four hoisting belts are the same length
to avoid cabinet skew during movement. As shown below.
• After moving to the destination, please lock the four casters to se-
cure the cabinet.
• The cabinet should be placed on a level ground. It is forbidden to
place the cabinet on a sloped ground.
Copyright © Itech Electronic Co., Ltd.
23
To Next Page
Loading...
Need help?
General
