Battery Simulation Function
Copyright © Itech Electronic Co., Ltd. 52
Channel selection: Channel 1, Channel 2. (Only
IT6402/IT6412/IT6412S contain this menu.)
Select mode: Charge (battery charge mode),
Discharge (battery discharge mode), Simulator
(battery characteristic simulation)
Configure various parameters for battery
characteristic simulation on the panel.
Toggle key of Waveform Display interface: when
this key is pressed, the present interface is ended
and switched to the Graph interface.
Configure the stop conditions for battery
charging/discharging/simulation test
Introduction of Battery Charger interface
⚫ IT6411/IT6431/IT6432/IT6433/IT6411S/IT6432S
⚫ IT6402/IT6412/IT6412S
To Next Page
Loading...
Need help?
General
