List Function
Copyright © Itech Electronic Co., Ltd. 71
⚫ IT6402/IT6412/IT6412S
4. Press the [On/Off] key on front panel CH1 of the power supply to switch on
the CH1 output.
5. Press the [Trig] key on the front panel to trigger the running of List
document under editing. At this time, the status bar displays ,
indicating that the List is running.
Exit LIST
Refer to the steps below to exit the present List operation mode.
1. Press the [Sequence Sel] soft key on the List interface to enter the
Sequence Configuration interface.
2. Press the [ON CH1] soft key to set the List status as OFF. And the
instrument will exit the List operation mode.
To Next Page
Loading...
Need help?
General
