ITech IT8500plus Series - Chapter4 Status Commands; Status:questionable[:Event]; Status:questionable:condition; Status:questionable:enable <Nrf

Status Commands
Copyright © ITECH Electronic Co., Ltd. 18
Chapter4 Status Commands
Those commands configure the status registers of the electronic load.
STATus:QUEStionable[:EVENt]?
This query returns the value of event register. Event register is read only
register, it keeps all events sent to it. Read the quest event register will clear it.
Query Syntax
STATus:QUEStionable[:EVENt]?
Parameters
None
Examples
STAT:QUES:EVEN?
Returned Parameters
<NR1>
Related Commands
*CLS
STATus:QUEStionable:CONDition?
This command can read the parameter from quest condition register. It is a read
only register, keep the real-time(not locked) query status of the load.
Query Syntax
STATus:QUEStionable:CONDition?
Parameters
None
Examples
STAT:QUES:COND?
ReturnedParameters
<NR1>
Related Commands
STAT:OPER:COND?
STATus:QUEStionable:ENABle <NRf+>
This command is used to set the value of the enable register.