ITech IT8500plus Series - Measure[:Scalar]:Current:minimum; Measure[:Scalar]:Current:ptpeak; Measure[:Scalar]:Power[:DC]

Measure Commands
Copyright © ITECH Electronic Co., Ltd. 46
Examples
MEAS:CURR:MAX?
Returned Parameters
<NR2>
MEASure[:SCALar]:CURRent:MINimum?
This command is used to query the minimum current of the electronic load.
Command Syntax
MEASure[:SCALar]:CURRent:MINimum?
Parameters
None
Examples
MEAS:CURR:MIN?
Returned Parameters
<NR2>
MEASure[:SCALar]:CURRent:PTPeak?
This command is used to query the current peak-to-peak value.
Command Syntax
MEASure[:SCALar]:CURRent:PTPeak?
Parameters
None
Examples
MEAS:CURR:PTP?
Returned Parameters
<NR2>
MEASure[:SCALar]:POWer[:DC]?
This command is used to query the power average.
Command Syntax
MEASure [:SCALar]:POWer[:DC]?
Parameters
None