ITech IT8500plus Series - Timing:tstart:source; Timing:tstart:edge; Timing:tstart:level

Timing Test Commands
Copyright © ITECH Electronic Co., Ltd. 60
TIMing:TSTart:SOURce
This command sets the trigger source for starting the test.
Command Syntax
TIMing:TSTart:SOURce <source>
Parameters
VOLT|CURR|EXT
Examples
TIM:TST:SOUR VOLT
Query Syntax
TIMing:TSTart:SOURce?
Returned Parameters
<source>
TIMing:TSTart:EDGE
This command is used to set the trigger edge of the start test.
Command Syntax
TIMing:TSTart:EDGE <edge>
Parameters
RISE|FALL
Examples
TIM:TST:EDGE RISE
Query Syntax
TIMing:TSTart:EDGE?
Returned Parameters
<edge>
TIMing:TSTart:LEVel
This command is used to set the trigger level for the start test.
Command Syntax
TIMing:TSTart:LEVel <Nrf+>
Parameters
Depends on the start trigger source, which is the setting of the
Timing:TSTart:SOURce command.