IEEE488 Commands
Copyright © ITECH Electronic Co., Ltd. 68
Related Commands
*TRIG *WAI
*OPC?
This command is used to query whether the command execution is completed
or not.
Command Syntax
*OPC?
Parameters
None
*PSC
This command is used to control whether the electronic load will generate a
service request when power on again.
1 OR ON: When the load power on, status byte enable register, operater event
enable register, query event enable register and standard event enable register
will be cleared.
0 OR OFF: The value of status byte enable register, operater event enable
register, query event enable register and standard event enable register will be
stored in the none-volatile storage, which will be recalled when power on.
Command Syntax
*PSC <bool>
Parameters
0|1|ON|OFF
Query Syntax
*PSC?
Returned Parameters
0|1
*PSC?
This command is used to query the status byte enable register.
Command Syntax
*PSC?
Returned Parameters
0|1|ON|OFF
To Next Page
Loading...
