Input Settings
Copyright © ITECH Electronic Co., Ltd. 32
[SOURce:]FUNCtion <function>
[SOURce:]MODE <function>
These two commands are equivalent and are used to select the input mode of
the load.
Command Syntax
[SOURce:]FUNCtion <function>
[SOURce:]MODE <function>
Parameters
CURRent | VOLTage | POWer | RESistance | DYNamic | LED | IMPedance
⚫ CURRent: Constant Current Mode
⚫ VOLTage: Constant Voltage Mode
⚫ POWer: Constant Power Mode
⚫ RESistance: Constant Resistance Mode
⚫ DYNamic: Dynamic Operation Mode
⚫ LED: LED Mode
⚫ IMPedance: Constant Impedance Mode
*RST Value
CURRent
Examples
MODE RES
Query Syntax
[SOURce:]FUNCtion?
[SOURce:]MODE?
Returned Parameters
<CRD>
[SOURce:]FUNCtion?
[SOURce:]MODE?
These two commands are equivalent and are used to query the input mode of
the load.
Command Syntax
[SOURce:]FUNCtion?
[SOURce:]MODE?
Returned Parameters
CURRent | VOLTage | POWer | RESistance | DYNamic | LED | IMPedance
To Next Page
Loading...
Need help?
General
