ITech IT8500plus Series - [Source:]Dynamic:slew; [Source:]Dynamic:slew:rise <Nrf; [Source:]Dynamic:slew:rise

Input Settings
Copyright © ITECH Electronic Co., Ltd. 41
[SOURce:]DYNamic:SLEW?
This command is used to query the current slope in dynamic mode.
Command Syntax
[SOURce:]DYNamic:SLEW?
Parameters
None
Unit
A/uS
*RST Value
MAX
[SOURce:]DYNamic:SLEW:RISE <NRf+>
This command is used to set the current rising slope in dynamic mode.
Command Syntax
[SOURce:]DYNamic:SLEW:RISE <NRf+>
Parameters
MIN~MAX|MINimum|MAXimum
Unit
A/uS
*RST Value
MAX
Examples
DYN:SLEW:RISE 3
Query Syntax
[SOURce:]DYNamic:SLEW:RISE?
Returned Parameters
<NR2>
[SOURce:]DYNamic:SLEW:RISE?
This command is used to query the current rising slope in dynamic mode.
Command Syntax
[SOURce:]DYNamic:SLEW:RISE?