FC300 Getting Started Guide 63
Proprietary and Confidential
4. Remove the slider clip by pinching the webbing and sliding it
out of the clip ends.
5. Lay out the belt so that the front of the remaining buckle end (5)
is down, as is the adjustable slider (1).
Stretch out the rest of the belt so it is flat. The doubled-end of the
belt (from which you just removed the three-prong buckle end)
should be facing up.
6. Grab the unthreaded doubled-end and thread it through the
holster's belt loop so the webbing doubled-end is facing away
from the holster.
7. Try on the belt with attached holster to make sure the front of the
buckle clasp and the adjustable slider is on the side of the belt
away from your body.
To Next Page
Loading...
Need help?
General