ITRON FC300 - Page 72

Accessories
64 FC300 Getting Started Guide
Proprietary and Confidential
8. To rethread the three-prong buckle end with the webbing, grasp
the webbing doubled-end and insert it through the bottom slot of
the three-prong buckle end. Be sure you insert from the back of
the buckle; there is a slight curvature to the buckle. Insert the
webbing doubled-end into the concave curved side.
9. Loop the webbing and insert the webbing doubled-end into the
top slot of the three-prong buckle end.
10. Pull the webbing so there is a tight fit on the three-prong buckle
end.
11. Reattach the slider clip by pinching the webbing and sliding the
clip in pace. Be sure the clip opening is up.