5.6 Recommendations
DO List
• Read and keep your manual in a safe place.
• Increase chlorine production rate before a large number of bathers enter the pool and return to normal
afterwards.
• Increase chlorine production rate when temperature goes up.
• Increase chlorine production rate when the number of bathers goes up.
• Use stabilizer (cyanuric acid) to stabilize chlorine in pool.
• Mount power center in shade or out of the direct sunlight whenever possible.
• Decrease production rate when temperature goes down (for example, in the Fall and Winter seasons).
• Take pool water sample to pool professional once per month.
DON’T List
• Do not get fertilizer in your pool. Fertilizers contain nitrates which cause a high chlorine demand on
pool water.
• Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal
dilution of pool water with fresh water. A build up of by products can damage the electrolytic cell.
• Do not add chemicals or salt to the pool unless the chlorinator is turned off.
• Do not let chlorine stabilizer (cyanuric acid) drop below 50 PPM.
• Do not add salt without rst checking the pool salinity level. Too much salt can disable and possibly
damage the chlorinator.
Page 36
ENGLISH
Page 36
ENGLISH
Jandy
®
AquaPure
®
/PureLink™ Power Center and Cell Kit
|
Installation and Operation Manual
To Next Page
Loading...
Need help?
General
