Janome Skyline S9 - Page 104

102
Wi-Fi
®
Setting Mode
Connecting Wi-Fi Network
A wireless router device that complies with the
IEEE802.11b/g/n wireless standard is required for
connecting your machine with a Wi-Fi network.
Starting Wi-Fi connection
To start the Wi-Fi settings, press “ON”
q. The network
setting button y is enabled.
Press the network setting button y to enter the network
settings.
Choose one of the 4 methods to connect with the Wi-Fi
connection (see pages 103-104).
q Wi-Fi connection
The default setting of the Wi-Fi connection is “OFF”.
Press “ON” to enable the Wi-Fi connection.
The Wi-Fi connection and the network setting button y
are enabled.
Press “OFF” to disconnect the Wi-Fi connection.
w Network Name
The name of the wireless network (SSID) connected with
your sewing machine is displayed.
The lock icon o appears if the connected access point is
secured with an encryption key.
e IP Address
The IP address of your machine is displayed.
“(DHCP)” is displayed in front of the IP address when the
DHCP option is turned on.
The IP address can be changed in the network settings.
r MAC Address
The MAC address of the sewing machine is displayed.
t Sewing Machine Name
The sewing machine name for network identication is
displayed.
The sewing machine name can be changed in the
network settings.
y Network setting button
Press this button to open the Network Settings window.
u OK key
Press this key to conrm the Wi-Fi connection setting.
i Cancel key
Press this key to cancel the Wi-Fi connection setting.
w
e
q
r
t
y
o
NOTE:
The use of home appliances such as a microwave
oven, bluetooth devices or cordless phones can
reduce the range of the Wi-Fi connection (if
your wireless router's network standard is using
IEEE802.11b or IEEE802.11g).
You may need to reduce the distance between your
machine and the wireless LAN access point, or install
the wireless LAN access point at an appropriate
location.
NOTE:
If you select WEP for the security setting of your wireless
LAN router, check the followings:
• Select “ASCII” for the encryption type.
• Select the initial number for the key index number
(The initial number can be “0” or “1”, depending on the
wireless LAN router.).
For setting up, refer to your wireless router’s instructions.
u i