Janome Skyline S9 - Page 105

103
e Search for access point
Press “Search” e.
The machine will search for any wireless LAN access
point within the range, and the names of network will be
listed.
The lock icon t appears on the right side of the list if the
connection requires an encryption key to get connected.
The signal strength icon y shows the strength of the
connection signal. The number of waves above the dot
indicates the signal strength of the wireless connection.
Press the wireless network name you would like to
connect with.
NOTE:
If you cannot nd the wireless LAN access point you
are looking for, press the refresh key u to search for
the wireless LAN access point again.
If the selected wireless network requires an encryption
key for connection, the Encryption Key Entry dialog box
appears. Be careful to enter uppercase or lowercase
letters required.
Enter the encryption key and press the OK key to
establish the network.
Press show/hide key i to show or hide the entry.
q
e
w
r
Network Settings
NOTE:
Please refer to your wireless router's instructions when
the using the push-button or PIN method to connect
with the Wi-Fi connection.
q Wi-Fi Protected Setup™* push-button
conguration method
Press “WPS (PBC)” q.
The WPS Push-Button Sys. dialog box appears on the
screen. Press the Wi-Fi Protected Setup™ button on the
wireless LAN router.
The dialog box appears and the wireless LAN router will
automatically connect with your machine.
To use the Wi-Fi Protected Setup™ push-button
conguration method, the wireless router must support
this method. Please also refer to the wireless router’s
instructions about this method.
w Wi-Fi Protected Setup™ PIN method
If the wireless router supports the Wi-Fi protected
Setup™ PIN method, you can connect the machine using
the method.
Press “WPS (PIN)” w. The WPS PIN Code System
dialog box appears.
Register the PIN code to the router before the PIN Code
System dialog box is closed to establish the network.
To enter the PIN code to your wireless router, please
refer to the instructions of your wireless router’s Wi-Fi
Protected Setup™ PIN method setup.
y
u
t
NOTE:
The machine displays “Connection to the network
failed” if it cannot receive the signal from the wireless
LAN access point within 2 minutes.
NOTE:
The machine displays “Connection to the network
failed” if the Wi-Fi connection is not established within
2 minutes.
i
* Wi-Fi Protected Setup™ is a trademark of Wi-Fi Alliance
®
.