Janome Skyline S9 - Page 156

154
Thread cutting
There are 3 thread cutting options for embroidery.
o Jump thread cutting length
When this option is turned on, the machine trims the
jump threads if the jump thread length is the same or
more than the set value. Jump thread cutting length can
be set from 3 mm to 30 mm or off.
!0 Cut at color change/end
When this option is turned on, the machine trim the
thread when it stops to change the thread to the next
color.
!1 Cutting command
When this option is turned on, the machine trim the
threads at the trim code if the imported stitch data le
contains a trim command (cutting command).
!2
o
!0
!1
!3
!2 Easy setting
When this setting is turned on, the machine will trim the
threads if the jump thread is 3 mm or longer, or when the
machine stops to change the thread to the next color.
Press the OK key to conrm the easy setting.
!3 Advanced setting
When this setting is turned on, you can congure the
Jump thread cutting o, Cut at color change/end !0, and
Cutting Command !1 options individually.
Press the next page key to go to the next menu.