IFC-3030 Programming Manual — P/N 52025:C 08/05/2005 133
Appendix G: Type Codes
G.1 What are Type Codes?
Type Codes are software selections for initiating devices (detectors and monitor modules) and
output devices (control modules, NACs, and Panel Circuits). Some Type Codes are self-
explanatory; that is, the Type Code matches the function of the device, such as a “Monitor” for a
monitor module, “Smoke(photo)” for a photoelectric detector, and so on. Type codes also provide
special functions, such as activating switches, solenoids, and control panel functions. FlashScan
devices are assigned a special FlashScan code.
G.2 How to Select a Type Code
Type Codes are selected at the Point Programming screens. Refer to the Point Program section of
this manual for instructions.
This appendix contains detailed descriptions of Type Codes for input and output devices, as listed
below:
Type of Device Refer to page
G.3.2, "Type Codes for Intelligent Detectors"Intelligent
Detectors
page 134
Monitor ModulesG.3.3, "Type Codes for Monitor
Modules"
page 135
SLC and Panel Circuit Outputs page 136
FlashScan Codes page 137
To Next Page
Loading...
Need help?
General
