Johnson Controls IFC-3030 - Fire Alarm Event; How the Control Panel Indicates a Fire Alarm; How to Respond to a Fire Alarm

IFC-3030 Programming Manual — P/N 52025:C 08/05/2005 23
Panel Program Program
LOCAL SETTINGS:Press this soft key to proceed to the Local Settings screen. Press the soft key
to scroll through the selections. The default is that there are no special local settings. Other settings
are explained in Appendix I, “Local Settings”.
DEFAULT SETTINGS: Press this soft key to activate default settings for the following:
Reminder Menu
Press the Reminder Menu soft key on the Panel Program Menu 1 screen to set the trouble reminder.
Figure 3.7 Reminder Menu Screen
Soft Keys
TROUBLE REMINDER: Press this soft key to toggle between the two possibilities:
YES: Choose this to initiate a daily 11:00AM reminder that there are uncleared troubles in the
system. The reminder will appear on the screen and will sound a piezo (if the piezo is enabled).
NO: Choose this if no reminder is desired. Default: YES
ACCEPT: Press this soft key to save the information entered on this screen.
3.2.4 Panel Timers (Menu 1)
Press the Panel Timers soft key on the Panel Program Menu 1 screen to display the following
screen.
Program setting for: Default:
Local Control Yes
Piezo On
Proprietary Supervising
Station
No
Event Ordering USA
Display Address Yes
LCM Local Mode No
Panel Circuit Bell Coding March
DCC Participation No
REMINDER MENU
TROUBLE REMINDER: YES
ACCEPT
BACK