IFC-3030 Programming Manual — P/N 52025:C 08/05/2005 141
Appendix I: Local Settings
The panel programming LOCAL SETTING choices, available through the Panel Settings (2) screen
(refer to page 22) are described below. The Local Settings screen (Refer to Figure I.1) allows
scrolling through the available choices by pressing the soft key. Choices are Chicago, Singapore, or
Default (no special local settings).
Figure I.1 Local Settings Screen
I.1 Singapore
The LOCAL SETTING choice of SINGAPORE:
• Does not allow the disabling of a bell circuit either locally or via the network.
• Does not turn ON the System Trouble LED or the System Trouble relay for disabled points.
• Does not turn ON the System Trouble LED, the System Trouble relay, or the piezo when
Drill is initiated.
• Turns ON keypad LEDs, PCB LEDs, Panel Circuit LEDs, and all ACM-24/48 LEDs during
Lamp Test.
• Requires the user to initiate the start of the application when the panel boots/reboots. The
CPU Failure LED will be ON until the user initiates startup. (Refer to Figure I.2.)
Figure I.2 Singapore Application Initiation
LOCAL SETTINGS
LOCAL SETTINGS:SINGAPORE
TROUBLE
LOADING..NO SERVICE
LAKEVIEW GENERAL HOSPITAL
N083
BOOTLOADER
11:58:45A WED AUG 25, 2004
CPU HAS REBOOTED
CONTINUE ABORT
User should select CONTINUE
to initiate applications.
User should select ABORT to
abort applications.
To Next Page
Loading...
Need help?
General
