20 IFC-3030 Programming Manual — P/N 52025:C 08/05/2005
Program Panel Program
IP ACCESS Screen
This screen allows the programmer to set the IP Access. This setting allows the disabling/enabling
of commands, downloads and programming from the Wide Area Network (WAN).
Figure 3.4 IP Access Screen
Soft Keys
IP ACCESS: Press the soft key to scroll through the choices. Press ACCEPT at the desired setting.
Settings are:
ON - IP commands, downloads and programming are allowed.
OFF - IP commands, downloads and programming are NOT allowed. (default)
TIMED - IP commands, downloads and programming are allowed for a two-hour period, after
which the setting will revert to OFF.
NOTE: Use of the IP ACCESS feature is subject to the approval of the local AHJ.
IP ACCESS
IP ACCESS: ON
ACCEPT
BACK
NOTE: Enabling IP ACCESS allows downloads over a local area network (LAN) or the internet
(Wide Area Network - WAN) using VeriFire Tools through a Noti•Fire•Net™ Web Server (NWS),
or a wide-area enabled NCS through a PC version of Noti•Fire•Net™ Gateway.
Always verify system operation after programming changes are made in this manner.
To Next Page
Loading...
