JR Vibe 90SG - Fuel Tank Assembly; Frame Support Assembly

10
Silicone Tube (small)
Tank Metal S
Tank Cap
Fuel Tank
Fuel Tank Clunk
Silicone Tube (not included)
Silicone Tube (not included)
Important: Remove
ashing around
opening and any debris
inside fuel tank before
assembly.
1-7
1-8 FRAME SUPPORT ASSEMBLY
Connect to Muer
Connect to carburetor in Step 3-5.
in Step 3-5.
(Fuel lter is not included)
FUEL TANK ASSEMBLY
Socket Head Bolt, 3 x 25mm (1pc)
Socket Head Bolt, 3 x 25mm
Tank Metal L
Fuel Tank Tube
97mm
Cut to a length of 97mm
Silicone Tube (small)
15mm
Flat Head Bolt, 3 x 6mm (4pcs)
Socket Head Bolt, 3 x 6mm (2pcs)
Socket Head Bolt, 3 x 6mm (2pcs)
Cross Member with Steps L32P20 (3pcs)
Flat Head Bolt, 3 x 6mm (4pcs)
Cross Member with Steps L32P20 (3pcs)
deR
)2x(
deR
(x4)
Frame Support Plate
Note: Install the aluminum tube in
thetop/centerofthetankopening
so that it will line up with the
opening in the engine mount block.