Socket Head Bolt, 4 x 8mm (2pcs)
Clutch Assembly
Nut (Supplied with Engine)
Taper Collet Upper
Cooling Fan Hub
Cooling Fan Blades
Button Head Bolt, 3 x 6mm (4pcs)
Taper Collet Lower
Washer (Supplied with Engine)
Flat Head Screw, 2 x 8mm
Steel Joint Ball
Hex Nut, 2mm
deR
)4x(
Note: It is recommended
that a crankshaft (not
piston) locking tool be used
to properly secure the fan
assembly to the engine.
3-2 C OOL I NG FA N/ C LUTCH INST A LL A T I ON
Flat Head Screw, 2 x 8mm (1pc)
Steel Joint Ball (1pc)
Button Head Bolt, 3 x 6mm (4pcs)
Hex Nut, 2mm (1pc)
Tapered Collet Upper (1pc)
Tapered Collet Lower (1pc)
deR
Socket Head Bolt, 4 x 8mm (2pcs)
Flat Washer, 3mm (4pcs)
Socket Head Bolt, 4 x 15mm (4pcs)
Flat Washer, 4mm (4pcs)
Engine Mount
Socket Head Bolt, 4 x 15mm (4pcs)
Flat Washer, 4mm (4pcs)
Flat Washer, 3mm (4pcs)
Top
Short
Long
deR
)2x(
Note: When securing the engine
bolts (4pcs), rst install them loosely.
Most engines have oversize clearance
holes in the mounting lugs. To take up
this clearance slop and have perfect
engine alignment, push up or down
evenly on the engine and nal tighten
the engine bolts.
To Next Page
Loading...
