JR Vibe 90SG - Main Frame Assembly 1

12
Bearing Block with Bearing, 12 x 24 x 6mm
Bearing, F4 x 10 x 4mm (2pcs)
Bearing Case Direction
Top
Main Frame L
Main Frame R
Socket Head Bolt, 3 x 10mm (6pcs)
(ALL)
deR
(x2)
JB Weld
2-1 MAI N F R A ME ASSEMBLY 1
Socket Head Bolt, 3 x 8mm (10pcs)
Socket Head Bolt, 3 x 10mm (6pcs)
Flat Washer, 3mm (2pcs)
Note the proper direction
and Bearing Blocks.
of the Main Frame L / R
Socket Head Bolt, 3 x 8mm (10pcs)
Brace Plate Mount (4pcs)
Socket Head Bolt,
3 x 6mm (2pcs)
Lower Bearing Block with Bearing, 12 x 24 x 6mm
Cross Member
with Steps L32P20
Flat Washer, 3mm (2pcs)
Cross Member, 32mm (2pcs)
Cross Member,
with Steps 32mm (2pcs)
Socket Head Bolt, 3 x 6mm (2pcs)
Cross Member with Steps L32P20 (1pc)
Cross Member, 32mm (2pcs)
Cross Member with Steps 32mm (2pcs)
Top
Caution: Use care to prevent any
adhesive from getting in the race of
the bearings.
Note: Note the proper assembly
directionoftheMainFrameL/Rand
install elevator bearings in correct
L/Rsideframesoninsidefaces.
JB weld or drop
ofCAisnefor
securing elevator
F4x10x4 bearings.
Note the proper direction
oftheMainFrameL/Rand
Bearing Blocks.