JR Vibe 90SG - Tail Gear Case Installation 1

36
Complete Assembly
Tail Output Shaft Stopper
Tail Gear Case Cross Member
Button Head Bolt, 3 x 6mm (4pcs)
Tail Gear Case Plate A
Tail Gear Case Assembly
Tail Gear Case Plate B
Setscrew,
4 x 4mm (2pcs)
Poly Slider, 6 x 9.5 x 0.13mm
(for gear mesh adjustment)
Button Head Bolt, 3 x 8mm (2pcs)
(x2)
deR
5-3 TAI L G E A R CA SE INST A LL A T I ON 1
Poly Slider, 6 x 9.5 x 0.13mm (1pc)
Button Head Bolt, 3 x 6mm (4pcs)
Button Head Bolt, 3 x 8mm (2pcs)
Tail Pitch Base
Note the proper direction of
Tail Pitch Base and Tail Gear Case Plate.
Setscrew, 3 x 6mm
Tail Output Shaft
Bevel Gear Shaft
Bevel Gear Pin
Setscrew, 3 x 6mm
Bevel Gear T22 Input
Bevel Gear T22 Output
Bevel Gear Pin
Secure so that the Setscrews
engage in the D-shape recess.
Setscrew, 4 x 4mm (2pcs)
Setscrew, 3 x 6mm (2pcs)
Setscrew, 4 x 6mm (4pcs)
Bevel Gear Pin (2pcs)
Setscrew, 4 x 6mm (4pcs)
)4x(
deR
deR
(x4)
(x2)
deR
Tail Drive Joint
Washer, 6 x 10 x 0.5mm
Washer, 6 x 10 x 0.5mm (1pc)
deR
deR
Note: Finally tighten the Tail Output
Shaft Stopper setscrews after assembly
is complete to remove and allow free
play of the output shaft.