JR Vibe 90SG - Tail Boom Brace Assembly; Tail Boom Brace Installation

41
Lower Tail
Support Clamp
Upper Tail
Support Clamp
Tail Brace Tube (2pcs)
Tail Brace Connector (4pcs)
Horizontal Fin
Flat Washer, 3mm (2pcs)
Socket Head Bolt,
3 x 8mm (2pcs)
Socket Head Bolt,
2.6 x 12mm (4pcs)
Nylon Lock Nut,
3mm (2pcs)
deR
)2x(
)4x( dleW BJ
Position the horizontal n so that it is
level to the building surface (90 degrees
to the main rotor shaft) and tighten the
two Tail Support Clamp Bolts.
5-8 TAI L B OOM B R A CE ASSEMBLY
5-9 TAIL BOOM BRACE INSTALLATION
Socket Head Bolt, 2.6 x 12mm (4pcs)
Socket Head Bolt, 3 x 12mm (2pcs)
Nylon Lock Nut, 3mm (2pcs)
Flat Washer, 3mm (4pcs)
Note the proper direction
of the Tail Brace Connectors.
Note the proper direction
of the Lower Tail Support Clamp.
deR
)2x(
Socket Head Bolt, 3 x 8mm (2pcs)
Socket Head Bolt, 3 x 10mm (2pcs)
Button Head Bolt, 3 x 6mm (2pcs)
Socket Head Bolt,
3 x 10mm (2pcs)
Flat Washer,
3mm (2pcs)
Socket Head Bolt, 3 x 12mm (2pcs)
Button Head Bolt,
3 x 6mm (2pcs)
Front
deR
(x2)