Washout Base
Washer, 3x4.5x1mm (2pcs)
Washout Arm
Steel Joint Ball (6pcs)
Control Ball, 9mm
120/140 Swashplate Assembly
Control Ball, 9mm (2pcs)
Setscrew,
3x3mm (3pcs)
Joint Ball Spacer,
2.75mm (4pcs)
Flat Head Screw,
2x10mm (6pcs)
Socket Head Bolt,
3x14mm (2pcs)
Long Control Ball,
28.25mm (2pcs)
)2x( deR
)4x( deR
)3x( deR
Install the long control balls for
140 CCPM or the short control
balls for 120 CCPM depending
on the type you will use.
Note the proper direction
of the washout base.
It is a good idea to size the
ball links with the JR Ball
Link Sizing tool prior to
attachment.
4-1 SWA SH P L A TE/W A SHOUT INST A LL A T I ON
Socket Head Bolt, 3 x 14mm (2pcs) Washer, 3 x 4.5 x 1mm (2pcs)
Setscrew, 3 x 3mm (3pcs) Joint Ball Spacer, 2.75mm (4pcs)
Flat Head Screw, 2 x 10mm (6pcs)
Control Ball, 9mm (3pcs)
Steel Joint Ball (6pcs) Long Control Ball, 28.25mm (2pcs)
)3x(
deR
Hold Upper Plate
and check play.
Assembly (2pcs)
This Position
As shown in the gure below,
the JR PROPO logo on the washout
arm should be upside down.
140 CCPM
120 CCPM
Swashplate Limiter
If there is play between the upper and lower Swashplate, tighten
Setscrew 3 x 3mm to lower the swashplate little by little. Do not
overtighten as binding and damage to the bearing will occur.
To Next Page
Loading...
