Socket Head Bolt, 3 x 12mm (2pcs)
Rubber Grommets (4pcs)
Flat Washer, 3mm (2pcs)
Tip: Carefully cut out decals from provided decal sheet. Use
a spray bottle with two drops of dish soap and water to allow
Refer to the photos on the box for decal placement.
repositioning of the decals.
7-1 BODY/MAIN ROTOR BLADE ATTACHMENT
Socket Head Bolt, 3 x 12mm (2pcs)
Flat Washer, 3mm (2pcs)
Rubber Grommets (4pcs)
Check to ensure the body does not come in contact with any
portion of the main frame, muer, linkages, etc.
Trim for clearance if necessary.
Blade Holder
Main Rotor Blade
Bolt hole : 5mm
12mm thick grips
Length : 680 - 720mm
(not included)
Screw the Long Shank Bolt into the nylon grips (at the tip of the Lock Nut). The Main
Blades should be tightened so they can pivot when moderate pressure is applied. Don’t
allow the main blade to swing freely within the main blade holders. Tightening the Main
Blades too much will cause precession vibration.
To Next Page
Loading...
