JR Vibe 90SG - Page 56

56
H) Throttle Hold Setting
Move the roll selector to highlight the THRO HOLD function, then press the roll selector to enter the function.
Activatethethrottleholdfunction.Oncethethrottlelinkageissetup,settheholdpositioninthisfunctionsothat
when the throttle hold switch is pulled, the throttle servo does not move with the throttle stick at idle and throttle
trim set at the idle position. Press the LST key to return to the menu.
I) Gyro Sensitivity Selection
Move the roll selector to highlight the GYRO function, then press the roll selector to enter the function. Set the gyro
gainasshownasastartingpointfortheG7703Dgyro.Adjustthepercentageasnecessarywhenyingtheheli.
Othergyrosmayrequiredierentsettings;consultyourgyromanualforfurtherinformationonsettingthegain.
Press the LST key to return to the menu.
J) Governor
MovetherollselectortohighlighttheGOVERNORfunction,thenpresstherollingselectortoenterthefunction.Set
the governor settings as shown. Press the LST key to return to the menu.