JAX-9B W-FAX Installation Manual
iv
7ZPNA4096
Do not use organic solvents such as thinner or benzene to clean the surface. These agents
can damage the surface coating. Remove dirt and dust on the surface if any and wipe it with
a clean dry cloth.
Use the recording paper (6ZPTS00108) as specified by JRC.
The use of any other unspecified paper may cause recording density blurs, abnormal paper
feed, much dust, resulting in the damage of the recording device.
Connect the earth line to the earth terminal firmly.
Otherwise, it may cause an electric shock when the equipment has a failure or electric leak.
Do not rub the heating element (contacting with the papar) in the recording device with a
screwdriver, file or any other hard objects.
Otherwise, it destroys the recording device.
Do not store recording papers in the place exposed to a high temperature, high humidity or
direct sunlight. Otherwise, it may cause recording density blurs.
Do not connect the power cable to the common power outlet with any other cables with high
power noise (such as for an air conditioner). Otherwise, it may cause a receiving
interference.
Do not install the equipment on the unstable place such as on the shaky stand or inclined
surface. Otherwise, it may drop or fall down, resulting in an injury or malfunction.
Do not install the equipment under the direct sunlight.
The high temperature may discolor the recording paper or cause an equipment malfunction.
Do not install the equipment near any other radio equipment.
Otherwise, it may cause a receiving disturbance.
Do not bring the equipment in the cooled state suddenly to a high-temperature room.
Otherwise, the air inside the equipment may be condensated, resulting in a malfunction.
To Next Page
Loading...
Need help?
General
