Chapter5 Setup VDR/S-VDR by Maintenance software
VDR/S-VDR Real Time Monitor / Installation Manual
18
(6) Input check for real time output of necessary data.
Every data can be selected, and moreover all output can be set up by package with the [All Enable]
button and [All Disable] button.
[All Enable]: “✓”
is entered by package in check box of all the data which is possible to out.
[All Disable]: “✓”
is removed by package in check box of all the data which is possible to out.
(7) Make sure the setup, and click the [Set] button.
Maintenance software sends the setup data, and then reboots VDR/S-VDR automatically.
(8) If the maintenance software logs in VDR/S-VDR after restart, the setup for VDR/S-VDR Real Time
Monitor is completion.
(9) Click the [Logout] button, and quit the Maintenance software.
[All Enable]/
[All Disable]
Button
[Set] button
To Next Page
Loading...
