Chapter1 Installation Procedure
VDR/S-VDR Real Time Monitor / Installation Manual
1
Chapter1 Installation Procedure
General Procedure
(1) Mounting the necessary unit
(2) Wiring the cable connected unit in according with installation drawings
(3) Checking wiring condition
(4) Setup of VDR/SVDR by Maintenance software
(5) Setup of PC in which the VDR/S-VDR Real Time Monitor is installed
(6) Final check
When Radar IF is connected to VDR/S-VDR, VDR IF (Router)
should be connected for separation between Radar IF and user
LAN.
The Firewall of the VDR IF unit is invalidated beforehand at factory
shipment.
If the operation check is completion, the firewall should be
validated.
Attention
Note
This installation manual is described for version 1.2 of VDR/S-VDR
Real Time Monitor software.
Since the VDR IF (Router) model is changed from AR410 to
AR415S, do not mistake it.
Attention
To set up the VDR/S-VDR for VDR/S-VDR Real Time Monitor, use
the latest Maintenance software (Ver. 1.2.0A).
If your Maintenance software is old version, download the latest
version from Marin Service Home Page.
Attention
To Next Page
Loading...
