Chapter9 Appendix
VDR Real Time Monitor / Installation Manual
79
STEP 1 Set by Maintenance software
(1)Open the Option PC（VDR Real Time Monitor）screen.
(2)Click the [Receive] button to receive the VDR/S-VDR configuration data.
(3)Click the [All Enable] button.
(4)Check that the following addresses in VDR WAN and Option PC.
・ VDR WAN=192.168.0.254
・ Option PC=192.168.0.251
(5) If the IP address is different, open the Network screen by the [Edit] button, and change IP
address.
When the [Default] button is clicked, default IP addresses are input.
(6) Click the [Set] button.
Setting by the Maintenance software is completion above.
After this, operate on Server PC of the VDR/S-VDR Real Time Monitor.
[Default] button
VDR WAN
/Option PC
[All Enable]
button
To Next Page
Loading...
