JRC JFE-680 - Initial Setup and Configuration; Memory Length and Display Color Settings

4. Operation 27
4.5 Initial Setting
T
The following menu is displayed with [MENU]・INITIAL .
INITIAL
MEMORY LENGTH
24hr
COLOR
＞
DEPTH DISPLAY MODE
TRAN
PRIMARY
＞
SECONDARY
＞
DATE/TIME
＞
・A present selection item is displayed by a yellow character.
・Selecting items move a yellow display with or key.
・When or the [ENT] key is pressed after a necessary item is selected, the item setting content is
displayed.
・When the [ENT] key is pressed after the content is selected (setting), the selection (setting) is registered
and it returns to above screen.
・When returning to above screen without registering, press or the [CLR] key.
Setting Memory length
◎The memory length of the sounding data displayed in the history mode is set.
・Make MEMORY LENGTH a yellow display, press or the [ENT] key, and select it from the following,
set content.
Set content ：12hr/24hr
12hr ：The memorizing length is set to 12 hours. (Memorizing interval is 30 seconds.)
24hr ：
The memorizing length is set to 24 hours. (Memorizing interval is 1 minute.)
・Select the length by and press the [ENT] key.
Setting Display Color of Day/Night
◎When switching with the [DAY/NIGHT] key, the image color and the character color are set.
・Make COLOR a yellow display, press or the [ENT] key, and the menu under the left is displayed.
COLOR
DAY1
D AY 1
＞
SCREEN
2
DAY2
＞
CHARACTER
1
NIGHT1
＞
NIGHT2
＞
・
After the item is selected with or key
,
when
key is pressed, a right menu is
displayed.
・
As for a set menu of DAY1～
NIGHT2, the
same content is displayed.
※
A left, set content is an initial value.
This Initial Settings use for service engineer
only. Do not change the settings. If you change
the Initial settings, malfunction might occur.