JRC JFE-680 - Communication Protocols and Data Output; Depth and Alert Output Settings

4. Operation 36
4.7 Communication Setting
The following menu is displayed with [MENU]・COMMUNICATION .
COMMUNICATION
DEPTH
ALL
ALERT
ON
SYSTEM
ON
PRINTER PORT OUT
PRINTER
・A present selection item is displayed by a yellow character.
・Selecting items move a yellow display with or key.
・When or the [ENT] key is pressed after a necessary item is selected, the item setting content is
displayed.
・When the [ENT] key is pressed after the content is selected (setting), the selection (setting) is registered
and it returns to above screen.
・When returning to above screen without registering, press or the [CLR] key.
Setting Depth Output
・Make DEPTH a yellow display, press or the [ENT] key, and select it from the following, set content.
Set content ：Ver1.5/Ver2.3/ALL
Ver1.5 ：Setting of DEPTH DISPLAY MODE in “INITIAL" of the menu;
Only “SDDBS" is output for 「SURF」.
Only “SDDBT" is output for 「TRAN」.
Only “SDDBK" is output for 「KEEL」.
Ver2.3 ：“SDDPT" is output.
Ver5.0 ：Alert serial data change to meet IEC61162-1ed5
ALL ：
Both content of “Ver1.5" and “Ver2.3" are output at the same time.
・“PJRCU" is output as for each setting of “Ver1.5/Ver2.3/ALL".
・Select the content by and press the [ENT] key.
Setting Alert Output
・Make ALERT a yellow display, press or the [ENT] key, and select it from the following, set content.
Set content ：OFF/ON
OFF ：When warning starts, the ALR sentence is not output. (Data as the history remains.)
ON ：“
SDALR" is output for all items of alert setting “ON" in the alert setting menu by a
period for one second.
・Select the content by and press the [ENT] key.
※
A left, set content is an initial value.