JRC JHS-32B - Page 5

- iii -
５．Select a combination of latitude / longitude
by
▼ ▲
key.
- - INPUT POSITION/UTC DATA - -
POSITION : N : E :
UTC : N : W :
DATE : S : E :
S : W :
SELECT WITH ▼ ▲ ,& PRESS ENTER．
PRESS CLR TO CANCEL．
６．
Press ENTER key.
- - INPUT POSITION/UTC DATA - -
POSITION : S . W .
UTC : 23:59 (HH:MM)
DATE : 31.12.99 (DD.MM.YY)
SELECT WITH ▼ ▲ , INPUT NO., &
PRESS ENTER ．
PRESS CLR TO CANCEL．
７．
Input the latitude / longitude numerical value.
- - INPUT POSITION/UTC DATA - -
POSITION : S12.34 W123.45
UTC : 23:59 (HH:MM)
DATE : 31.12.99 (DD.MM.YY)
SELECT WITH ▼ ▲ , INPUT NO., &
PRESS ENTER ．
PRESS CLR TO CANCEL．
８．
Press
ENTER
key.
- - INPUT POSITION/UTC DATA - -
POSITION : S12.34 W123.45
UTC : 23:59 (HH:MM)
DATE : 31.12.99 (DD.MM.YY)
SELECT WITH ▼ ▲ , INPUT NO., &
PRESS ENTER ．PRESS CLR TO RETURN．
PRESS STOP TO SET & RETURN．
･The selected combination of latitude
/
longitude is highlighted.
・
Selected coordinates are decided and
it will be in the input state of latitude
/
longitude numerical value.
・
「INPUT POSITION/UTC DATA」
screen
is displayed and it will be in a position
input state.
・ Example of an input in 12°34′of latitude：
press 1 2 3 4 keys.
・ Example of an input in 123°45′of longitude :
press 1 2 3 4 5 keys.
・ Decimal point key ･ is not required.
・ Press CLR when mis-input., then re-inpu
t
correct value.
･ Latitude / longitude is decided and it
will be in the state of a time input.