68
Setting and checking of various data can be performed with the information.
For the information, there are the operator level and the maintenance personnel level.
[Operator level]
2: Sewing common data
3: Sewing management
information
5) Press the reset switch to erase the pop-up. Press again the reset switch to return the value to the initial one
and re-start the sewing.
* When the thread remaining amount is large, or bobbin thread has run out before the bobbin thread counter
reaches minus, adjust the initial set value with “+” or “–” of bobbin thread amount setting switch.
* As a matter of fact, bobbin thread amount changes in accordance with the thickness of cloth or sewing
speed. Adjust the counter in accordance with the sewing conditions.
■Bobbin thread replacement warning pop-up
1
1) Turn ON the power. When the needle bar is not in the UP position, turn the handwheel to bring the needle
bar to its UP position.
2) Press switch 1 to display the information screen.
■Information screen (operator level)
2
3
2) Set the initial value with “+” and “–” switch. When the switch is held pressed and the set value exceeds the
digit of 100, the set value increases/decreases by 100 unit. When setting the value near to 100 digit, press
the switch each time.
3) Setting of the initial value is performed, start the sewing.
4) When the bobbin thread counter reaches minus and the buzzer beeps, the bobbin thread replacement
warning pop-up below appears.
6-15. Information
To Next Page
Loading...
Need help?
General
