1-64
(13) Before starting the aging, apply the NSL grease and move the HEAD_UNIT from the front to
the rear and from the rear to the front conform it to the entire shaft.
∗ Wipe off the oozed grease with a cloth rag.
(14) Perform the aging (warm-up_diagonal/high-speed 2) for about 8 hrs.
∗ 8 hrs. are reference value.
(15) Wipe off the grease splashed by the aging.
Wipe off the oozed grease with a
cloth rag.
The portions on the rear and front indicated by the red frames are
those where the grease splashes particularly. So, wipe off the grease
with a cloth rag.
To Next Page
