Industrial Sewing Machine SADE
16
The direction of normal rotation of the machine is counterclockwise as observed
from the pulley side. Take care not to allow the machine to rotate in the reverse di-
rection.
Never operate the machine unless the machine head and the oil tank have been
filled with oil.
For a test run, remove the bobbin and the needle thread.
For the first month, decrease the sewing speed and run the sewing machine at a
speed of 80% or less of the maximum sewing speed. As to the maximum sewing
speed, see "7.4. Sewing speed table".
Operate the handwheel after the machine has totally stopped.
During operation
Do not touch by body parts to electrical wires while machine is running.
Be sure not to put your fingers, hair or clothing close to the moving sections such
as the handwheel, hand pulley and motor or place something near those sections
while the machine is in operation in order to prevent accident caused by entan-
glement that can result in personal injury or death.
Be sure not to place your fingers near the surround area of the needle or inside
the thread take-up lever cover when turning the power on or while the machine is
in operation in order to prevent accident that can result in personal injury or death.
The machine runs at a high speed. Never bring your hands near the moving sec-
tions such as looper, spreader, needle bar, hook and cloth trimming knife during
operation in order to protect your hands against injury. In addition, be sure to turn
the power off and check to be sure that the machine completely stops before
changing the thread.
Keep your hands away from needle when you turn ON the power switch or while
the machine is in operation.
Do not operate your machine with finger guard removed.
While operating the machine operator should stand on the ground in front of the
machine and operate it by pedal placed on the ground.
Be careful not to allow your fingers or any other parts of your body to be caught
between the machine and table when removing the machine from or replacing it
on the table in order to prevent accident that can result in personal injury or death.
A servomotor does not produce noise while the machine is at rest. Be sure not to
forget to turn the power off in order to prevent accident caused by abrupt start of
the motor
Before leaving the machine (during any break) always turn the machine off and cut
the power supply off by removing the plug from the socket or by switching the
main switch at the control box to "0" (be sure to secure it against restarting).
The safety devices should be effective and should not be bypassed.
Efficient functioning of safety devices and of machine control are the responsibility
of competent workers, who should inform the manager of any hazards or errors
that occur during operation.
To Next Page
Loading...
Need help?
General
